Holmenkol SpareBlade Round
HOLMENKOL SpareBlade Round 6 mm is a round 6 mm carbide replacement blade for controlled removal of side-wall material. It is designed for precise workshop and race-service edge preparation with repeatable results.
Pickup available at Brucker Str. 49
Usually ready in 24 hours
HOLMENKOL · SpareBlade Round 6 mm · Edge tuning
HOLMENKOL SpareBlade Round 6 mm
Defined round cutting radius for repeatable trimming. This tool belongs in the geometry stage of edge preparation, before final diamond polishing and deburring.
Technical setup
Key specifications
Application & selection
Work with stable support and light pressure
Set up the tool before cutting, keep it flat against the intended reference surface and remove only as much material as necessary. Check progress frequently.
SF Sports recommendation
Protect the intended edge angle
Do not use edge tools to compensate for a poor side-wall setup. Clear the side wall first, then work the steel edge in progressively finer steps.
Related areas at SF Sports
FAQ
Frequently asked questions
What is SpareBlade Round 6 mm used for?
Controlled removal of side-wall material.
Is it a race-service tool?
Yes. It is designed for precise, repeatable edge preparation.
Should I use heavy pressure?
No. Controlled light-to-moderate pressure gives a more consistent result.
Does it replace diamond finishing?
No. Geometry and polishing are separate service steps.
Can it be used on snowboards?
Yes, where the specific tool geometry is compatible with the board setup.
Why is repeatability important?
Because small changes in edge angle or side-wall interference can noticeably change grip and handling.
What should I check before use?
Blade/tool condition, intended angle and a stable, clean reference surface.